Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!usc!cs.utexas.edu!uwm.edu!csd4.csd.uwm.edu!info-high-audio-request
From: asinger@rpi.edu (Adam J. Singer)
Newsgroups: rec.audio.high-end
Subject: Re: Connectors/Digital-output/Loudspeaker-design
Message-ID: <11828@uwm.edu>
Date: 6 May 91 12:53:35 GMT
Sender: news@uwm.edu
Lines: 27
Approved: tjk@csd4.csd.uwm.edu
Originator: tjk@csd4.csd.uwm.edu

I'm Planning on Building a set of *very* High end speakers over the summer,
For Woffers they wil use dual 12" drivers
for Tonal Bass two 8" drivers
for midrange two 4"-5" drivers
and a tweeter for highs
they wil be aligned in this arangement....
12
8
5
T
5
8
12
There is a possibility if I can find more info on them that the mids and highs 
will be replaced by an electrostatic driver in the design.

What I am looking for, is information on the construction of electrostatic 
drivers, and also information about any drivers you think would be good for 
my design(cone drivers that is)

I'm hoping for efficiancy in the 90 db range
a frequency range from 20hz-20+khz +- as close to zero as I can get it
I am willing to use electronics to get rid of bumps or dips in the response
curve.

Thanx for your help.
send emial to asinger@rpi.edu