Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!zaphod.mps.ohio-state.edu!sol.ctr.columbia.edu!src.honeywell.com!msi.umn.edu!cs.umn.edu!uc!noc.MR.NET!gacvx2.gac.edu!hhdist From: TNAN0@CCVAX.IASTATE.EDU Newsgroups: comp.sys.handhelds Subject: RE: MLDL 1.02 Message-ID: <7805B00E297FC08E3E@ISUVAX.BITNET> Date: 12 May 91 20:56:00 GMT Lines: 25 Return-path: To: handhelds@gac.edu X-VMS-To: IN%"handhelds@gac.edu" I just wanted to report that I am experiencing the same problem as Eric B. Davis... Once in a while (about 1 in 4), while I am using Jan's MLDL 1.02, I get "Invalid Card Data" and MLDL will be gone from both the library menu and from the PORT0 or PORT1 menu. However, if I take a mem, it shows that memory is still allocated to MLDL. Nothing short of a memory clear has helped this condition. I would like to thank Jan for MLDL. It is a wonderful piece of work! I found it difficult to believe what I was seeing the first time I used it. It's cut my development time 80% or more... However, this "Invalid Card Data" problem can slow me down quite a bit. I currently have ONLY MLDL loaded into the calculator, yet MEM is showing over 50K used. This is caused by this error. I haven't wanted to reload MLDL everytime it crashes, so I keep it stored in a variable as well. When it does crash, I just re-install it from the variable. But because its memory is still allocated, I can only do this 4 or 5 times before I am forced to clear the calculator's memory... Well, again... thanks for a wonderful program, Jan... ---Gary Snethen (Xeno) gsnethen@ultra.cnde.iastate.edu tnan0@isuvax