Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!zaphod.mps.ohio-state.edu!swrinde!mips!spool.mu.edu!news.nd.edu!mentor.cc.purdue.edu!noose.ecn.purdue.edu!orchestra.ecn.purdue.edu!songer
From: songer@orchestra.ecn.purdue.edu (Christopher M Songer)
Newsgroups: comp.sys.next
Subject: vt220 installation on an 040 Cube
Keywords: boot, rc.local
Message-ID: <1991May9.143453.17407@noose.ecn.purdue.edu>
Date: 9 May 91 14:34:53 GMT
References: <1991May9.141033.4397@eng.ufl.edu>
Sender: root@noose.ecn.purdue.edu (ECN System Management)
Organization: Purdue University Engineering Computer Network
Lines: 13

Hi,

     I just picked up a vt220 and am ready to put it on my 040 Cube.
I've read quite a few posts about people putting terminals on their
machines, but most have cruised right over my head. If someone could
please send me information as to what I need to do in the software
to set up the terminal on serial port A (w/hardware control flow) as
well as what source of information I should use for getting pinouts
for the cable (I've heard some of the information in the on-line docs
is bogus) I'd really appreciate it!

Thanks!
-Chris