Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!sun-barr!olivea!uunet!mcsun!hp4nl!ctisbv!pim
From: pim@cti-software.nl (Pim Zandbergen)
Newsgroups: comp.unix.sysv386
Subject: restore console display and vt status (was: Re: xfig with X386)
Message-ID: <1991May9.142835.3424@cti-software.nl>
Date: 9 May 91 14:28:35 GMT
References: <1991Apr14.140430.23712@metro.ucc.su.OZ.AU>
Organization: CTI Software BV, The Hague, The Netherlands
Lines: 23

In article <1991Apr14.140430.23712@metro.ucc.su.OZ.AU> dawes@suphys.physics.su.OZ.AU (David Dawes) writes:
<I've had a problem with xfig causing the X386 server to crash.  This happens
<when I use Roell's binaries on an ESIX Rev D system (with ET4000 VGA).  xfig
<runs fine when the line thickness is set to zero, but drawing something
<with the line thickness greater than zero causes the server to crash.  When it
<crashes, the display gets stuck in graphics mode.  Its possible to switch
<to another vt, but you can't see what you type.

It is rather annoying when ones display is stuck in graphics
mode and/or vt's are left in an insane state. This can also
happen if VP/ix dies.

If a curses application dies, you can get back to a sane state
by typing 'stty sane' or 'stty $oldsttysettings' if you've saved
them.

Has anyone written a program that does a similar thing to your
console display and vt's ? I hate typing 'init 6' blindly.
-- 
Pim Zandbergen                          domain : pim@cti-software.nl
CTI Software BV                         uucp   : uunet!mcsun!hp4nl!ctisbv!pim
Laan Copes van Cattenburch 70           phone  : +31 70 3542302
2585 GD The Hague, The Netherlands      fax    : +31 70 3512837