Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!zaphod.mps.ohio-state.edu!cis.ohio-state.edu!tut.cis.ohio-state.edu!bgsuvax!gantzm From: gantzm@gantz.bowlgreen.oh.us (gantzm) Newsgroups: comp.unix.sysv386 Subject: AT&T SysV Rel 4.0 - Cry for installation help... Message-ID: <6Pqw21w164w@gantz.bowlgreen.oh.us> Date: 13 May 91 22:52:28 GMT Organization: Michael L. Gantz - Consultant Lines: 39 Ok here's the situation: ALR Business VEISA 486/33 17 Mega Bytes Memory Western Digital MFM controller 40 Mb Hard Disk 0 32 Mb Hard Disk 1 Monochrome display and card Archive VP402 Adapter Card Archive 60 Mb Tape Drive / Model 2060L??? Nothing else, all serial/par ports taken out. Software: AT&T Unix System V Rel 4.0 (Ver 2.1) Cartridge Tape Boot Version (2 boot disk/tape, etc) Problem: System boots from boot disks and prepares hard disk fine. System then reboots off of the hard disks. System asks if I want to install from Tape or Floppy disk, I answer Tape bacause thats all I have. Well after that, the tape light comes on, nothing happens , and the system then tells me to check my tape drive.... Has anyone gotten AT&T SysV Rel 4.0 to load off of an Archive tape drive????? I followed the settings in the book (IRQ=5, DMA=1, port = 288) and it doesn't work. I talked to Archive and they said to try port = 300, well on the address the tape light does not even come on. The Unix guru at Archive is out of the country till June. If anyone can help, Thanks in advance..... BTW: Yes, I'm the one with the SCSI problem, trying to get something to run, so I can rebuild the kernel...... The saga continues... --- Michael L. Gantz | gantzm@gantz.bowlgreen.oh.us 213 Napoleon Rd. | osu-cis!bgsuvax!gantz!gantzm Bowling Green, Oh 43402 | Mellon! I had only to speak the Elvish word for (419) 353-5029 | friend and the doors opened. - J.R.R. Tolkien