Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!sdd.hp.com!elroy.jpl.nasa.gov!swrinde!ucsd!ucbvax!cs.uni-sb.de!lupus From: lupus@cs.uni-sb.de (Markus Wolf) Newsgroups: comp.laser-printers Subject: Re: Printcap for HP Laserjet III query Message-ID: <9105151623.AA10919@crayola.cs.UMD.EDU> Date: 15 May 91 08:05:49 GMT References: <9105071855.AA21866@crayola.cs.UMD.EDU> Sender: daemon@ucbvax.BERKELEY.EDU Organization: Universitaet des Saarlandes, Saarbruecken, Germany Lines: 41 Approved: laser-lovers@brillig.umd.edu In article <9105071855.AA21866@crayola.cs.UMD.EDU> epperly@OSNOME.CHE.WISC.EDU (Tom Epperly) writes: Path: sbsvax!unido!mcsun!uunet!tut.cis.ohio-state.edu!ucbvax!OSNOME.CHE.WISC.EDU!epperly From: epperly@OSNOME.CHE.WISC.EDU (Tom Epperly) Newsgroups: comp.laser-printers Date: 7 May 91 17:29:26 GMT Sender: daemon@ucbvax.BERKELEY.EDU Organization: The Internet Lines: 20 > I am looking for a printcap for an HP laserjet III for a DECstation > 5000 running Ultrix 4.1 and the important printer settings that go > along with it. I have done lots of experimenting, and it seems that I > can't get the flow control to work. Anything under 10 pages prints > fine, but after 10 pages it halts and starts over. Please email me > any information you can. Here are some specific questions that I > have? > > - What is the best printcap for an HP laserjet III? > - What are the accompanying printer settings? > - What is rhobust flow control? > - What RS232 wires does the HP require/use? > > Please send whatever advice you can regardless of whether or not it > fits one of my questions. I would prefer to understand the problem > rather than just lower the baud rate. > > Tom Epperly > epperly@osnome.che.wisc.edu > te07@cs.cmu.edu We have the same Problem with our HP Laserjet III which is hooked up to a Sun 3/60 under SunOS 3.5. If anyone has an answer to this one please post a message to the net, it may be a general Problem of the HP LJ III. Markus Wolf lupus@cs.uni-sb.de Universit"at des Saarlandes