Path: utzoo!utgpu!news-server.csri.toronto.edu!bonnie.concordia.ca!thunder.mcrcim.mcgill.edu!quiche!yclept
From: yclept@cs.mcgill.ca (George FOSTER)
Newsgroups: comp.sys.amiga.hardware
Subject: Problem with ICD AdSCSI 2080 Card
Message-ID: <1991May17.155849.19956@cs.mcgill.ca>
Date: 17 May 91 15:58:49 GMT
Sender: news@cs.mcgill.ca (Netnews Administrator)
Organization: SOCS, McGill University, Montreal, Canada
Lines: 9
Originator: yclept@bart

I recently bought this card with 4 megs of RAM installed. It works fine
in my 2000 with a Quantum 80S hard drive, but only if I disable the RAM 
(via a couple of jumpers on the card). With the RAM enabled, the 2000
won't boot--the screen just cycles colours while the power light winks.

I've tried re-seating the SIMMs, swapping them, using only 2 megs, and
every reasonable combination of jumper settings, to no avail. Should I
just return the card, or is there something I'm missing? Thanks for any
help. (In case it's pertinent, I'm using WB 1.3 with 1.3 Kickstart ROMs).