Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!dali.cs.montana.edu!caen!zaphod.mps.ohio-state.edu!think.com!snorkelwacker.mit.edu!bloom-beacon!eru!hagbard!sunic!fuug!news.funet.fi!uwasa.fi!ts
From: ts@uwasa.fi (Timo Salmi)
Newsgroups: comp.lang.pascal
Subject: Re: HOW TO LET TP6.0 USE RAM DRIVE INSTEAD OF HARD DISK?
Message-ID: <1991May18.053326.16457@uwasa.fi>
Date: 18 May 91 05:33:26 GMT
References: <11907@j.cc.purdue.edu>
Organization: University of Vaasa, Finland
Lines: 17

In article <11907@j.cc.purdue.edu> zhou@brazil.psych.purdue.edu (Albert Q.Zhou) writes:
>My hard disk is a bit slow. So when I worked on TP5.5, I moved all tpu's
>to ram drive. However, on TP6.0, the hard disk is always being used. Is
>there any way to let TP6.0 use ram drive?

I'm not sure if I'm right and if this helps, but 4.0 had a somewhat
similar problem.  The solution then was transfer the necessary Turbo
Pascal entourage to the ramdisk.  It should not be overly difficult
to construct a batch to do the copying for you at the start of you
TP session.  (The reason I'm not sure, is that even if I have also
6.0, I prefer to use 5.0).

...................................................................
Prof. Timo Salmi
Moderating at garbo.uwasa.fi anonymous ftp archives 128.214.12.37
School of Business Studies, University of Vaasa, SF-65101, Finland
Internet: ts@chyde.uwasa.fi Funet: gado::salmi Bitnet: salmi@finfun