Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!swrinde!sdd.hp.com!hp-col!col!davem
From: davem@col.hp.com (Dave K. Martin)
Newsgroups: comp.sys.amiga.hardware
Subject: Re: Problem with ICD AdSCSI 2080 Card
Message-ID: <18730001@col.hp.com>
Date: 22 May 91 17:42:01 GMT
References: <1991May17.155849.19956@cs.mcgill.ca>
Organization: HP Colorado Springs Division
Lines: 15

Well, I don't know if this applies to your particular problem but I had the 
same problems when I upgraded to a GVP Series II HC+8.  My simms worked fine 
in my 8-up board and would work in my GVP card in my dealers machine but 
not in my A-2000.  After several days of swapping simms I finally got 
through to GVP's tech department.  There is a jumper on the GVP's that must
be set to allow the memory to work correctly with older motherboards (rev 4.x).
This was not mentioned anywhere in the manual and my dealer wanted me to 
take my system in for a motherboard upgrade (past service with this dealer 
indicated that this would have take about 3 months for them to add a couple
of resistors :-( ).  After setting the jumper, the GVP and memory has been 
working just fine (and all without the motherboard upgrade :-).

hope this helps....

davem