Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!think.com!zaphod.mps.ohio-state.edu!van-bc!ubc-cs!uw-beaver!zephyr.ens.tek.com!tektronix!percy!m2xenix!quagga!proxima!jsd
From: jsd@proxima.UUCP (Jeremy Druker)
Newsgroups: comp.unix.xenix.misc
Subject: Re: Xenix 2.3.2 and TCP/IP
Message-ID: <5538@proxima.UUCP>
Date: 20 May 91 16:55:34 GMT
References: <308@jabaru.oz.au>
Organization: FLAGSHIP Wide Area Networks - Cape Town
Lines: 26

Thus spake bevans@tanus.oz.au (Brian Evans Esq):

>I currently have xenix 2.3.2 installed with tcp configured for 1 SLIP line
>which is currently active.  I have just installed a wd8003e ethernet 
>controller and on installing the driver and relinking the kernel
>I key 'netsatt -r' and the system tells me that there are 2 wdn0
>interfaces on the system.

Sounds like the Xenix TCP installation installed initialization commands
for the WD card without first removing any existing ones.

Check /etc/tcp for lines of the form "ifconfig wd0 <stuff>" - there
should only be one.  Delete any others.
	
Next, check /etc/strcf (the slink config file) for more than one cenet
line naming /dev/wd in the boot() routine.  There should be only one.

Then reboot - that should do it.  A relink and new kernel should not 
be needed.

-J
----------------------------------------------------------------------------
  "Too bad she won't live ...           |                      Jeremy Druker
    ... but then again, who does?"      |                   jsd@proxima.UUCP
                   - Blade Runner       | ...!uunet!ddsw1!olsa99!proxima!jsd
----------------------------------------------------------------------------