Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!usc!sdd.hp.com!news.cs.indiana.edu!noose.ecn.purdue.edu!chunnel.ecn.purdue.edu!thomaz
From: thomaz@chunnel.ecn.purdue.edu (Jose E Thomaz)
Newsgroups: comp.sys.mac.hardware
Subject: Beginner's question! Hooking HP laserjet III to MacIIsi
Message-ID: <1991May26.225347.11574@noose.ecn.purdue.edu>
Date: 26 May 91 22:53:47 GMT
References: <9105221859.AA05533@thunder.LakeheadU.Ca> <13903@exodus.Eng.Sun.COM>
Sender: root@noose.ecn.purdue.edu (ECN System Management)
Organization: Purdue University Engineering Computer Network
Lines: 17


  Sorry if this is too simple a question, but I am new to MACs...
  I have a laserjet III that I want to connect to a Mac IIsi. I remember
  reading about a cable named **grapler a couple of years ago that would
  let me do that. Is such cable still available ?  (If so, which is the
  correct name? - I remember there were two versions then).

  Any other alternative is very welcome. This setup will be used at home.

  If this is a FAQ, please give me some pointers to the site where I can
  find informations..


 Thanks in advance

   J.Eduardo Thomaz
   thomaz@cn.ecn.purdue.edu