Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!usc!cs.utexas.edu!uunet!mnemosyne.cs.du.edu!isis!rwelch From: rwelch@isis.cs.du.edu (Randy S. Welch) Newsgroups: comp.sys.hp Subject: Re: GNU Make 3.59 on hp300 running hp-ux 7.0 Message-ID: Date: 27 May 91 04:30:15 GMT References: Sender: usenet@mnemosyne.cs.du.edu (netnews admin account) Distribution: na Organization: Public Access Unix - Univ. of Denver, Math Dept. Lines: 69 In-Reply-To: wayne@dsndata.uucp's message of 26 May 91 19:25:28 GMT In article wayne@dsndata.uucp (Wayne Schlitt) writes: Path: mnemosyne.cs.du.edu!uunet!zaphod.mps.ohio-state.edu!rpi!sci.ccny.cuny.edu!dsndata!wayne From: wayne@dsndata.uucp (Wayne Schlitt) Newsgroups: comp.sys.hp Date: 26 May 91 19:25:28 GMT References: Sender: wayne@dsndata.UUCP Distribution: na Organization: Design Data Lines: 45 In article sboucher@siegfried.vlsi.polymtl.ca (Stephane Boucher (PFE)) writes: > > I think I did a mistake while posting this message, so here it is > again. If you get this for the second time I apologize. > > Just a small question: > > Did anyone manage to have GNU make 3.59 running on an hp300 > running HP-UX 7.0. I did manage to compile it, but it won't work (core > dump). > > So if anyone has manage to make it run I would be grateful if > you could give me a hint. The makefile roughly is configured as follow: > > defines = -DHPUX -DUSG -DHAVE_SYS_WAIT -DHAVE_DUP2 > LOAD_AVG =-DNO_LDAV > ARCHIVES = arscan.o ar.o > ARCHIVES_SRC = arscan.c ar.c > LOADLIBES =-lPW > REMOTE = > extras = > i am currently using the following configuration and it seems to work fine. defines = -DUSG -DUSGr3 -DHPUX -DHAVE_SYS_WAIT -DHAVE_DUP2 LOAD_AVG = -DNO_LDAV ARCHIVES = arscan.o ar.o ARCHIVES_SRC = arscan.c ar.c LOADLIBES = REMOTE = extras = (i also compiled this using GCC, which may make a difference, but i am not sure...) -wayne If I remember correctly if you are compiling make on the HP you need to use alloca.c ( if you are using the hp compiler ). On a side note, does HP-UX 8.X suport multiple file systems on a disk, and can one take a form that is used on a LaserJet 2000 on a LaserJet IIIsi? -randy ( Greetings dsndata! ) -- Randy Welch Mail to : randy@bldr.UUCP or rwelch@isis.uucp or Boulder, CO rwelch@isis.cs.du.edu or (303) 442-6717 Have a Plexus? Subscribe to the plexus mailing list: plx-info-request@wpg.com General Requests: plx-info@wpg.com