Path: utzoo!utgpu!news-server.csri.toronto.edu!bonnie.concordia.ca!thunder.mcrcim.mcgill.edu!quiche!gerardis
From: gerardis@cs.mcgill.ca (Tony GERARDIS)
Newsgroups: comp.sys.ibm.pc.hardware
Subject: Epson Equity II+  (problems - Please help)
Message-ID: <1991May30.201331.22972@cs.mcgill.ca>
Date: 30 May 91 20:13:31 GMT
Sender: news@cs.mcgill.ca (Netnews Administrator)
Organization: SOCS, McGill University, Montreal, Canada
Lines: 27
Originator: gerardis@homer

A friend of mine has an Epson Equity II+ with a 40Mb Miniscribe hard
drive. There was recently a power failure (his system was on), and after
that time The computer doesn't recognize that there is a hard drive
connected. When you start up the hard drive light comes on and then
wants to boot of drive a:. As far as I'm concerned the CMOS got screwed
during the power failure!  However The system comes up with the error
"161- run setup in diagnostics
       options not set         "    ERROR.

He never got the Diagnostics disks with his system so I can't run Setup,
And Epson never bothered to put a built in hardware CMOS setup which
most companies do nowadays Which can be invoked from a simple keystroke!
EPSON is asking $60 for a simple setup program which should have been
included with the system.

If anyone HAS THIS DIAGNOSTICS DISK FOR THE EPSON computers Would you
please let me know!  

Maybe Someone can shed some light on this problem.
No, booting off floppy doesn't solve the problem. when I boot off floppy
and then try to switch to c: I get the Invalid drive specification
error.
------------------------------------------------------------
     gerardis@cs.mcgill.ca     | The sun is the same in a relative way,
			       | but you're older
			       | And shorter of breath and one day 
			       | closer to DEATH.       -Floyd