Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!think.com!zaphod.mps.ohio-state.edu!wuarchive!hsdndev!husc3.harvard.edu!hayward
From: hayward@husc3.harvard.edu
Newsgroups: comp.sys.mac.hardware
Subject: Wierdness in simm land (Help!).
Message-ID: <1991May30.181358.1223@husc3.harvard.edu>
Date: 30 May 91 22:13:58 GMT
Organization: Harvard University Science Center
Lines: 12

Hey folks,
	I got a problem. I just tried to install two .25 meg. simms into my
Mac+ and and couldn't get the mac to recognise there existance. One (of two) of
the 1 meg simms was strange looking it had four .25 meg. simm boards "piggy
backed" to form a 1 meg. simm. The jumper resistor wasn't cut either which I
thought was kind of strange. Well the mac. would not acknowledge the two new
simms anyway I tried to configure them. Any ideas? I have a "Max plus" ram
saver board installed also. Any info on the strange "piggyback" simm the jumper
wire not being cut and how I can get to 2.5 meg. would be much appreciated.
Thanks.

				Thatcher V.Hayward