Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!usc!wuarchive!uunet!mcsun!hp4nl!dri500!slootman
From: slootman@dri.nl (Paul Slootman)
Newsgroups: comp.unix.programmer
Subject: Re: Can you 'checksum' a file to see if it was changed?
Message-ID: <1084@dri500.dri.nl>
Date: 27 May 91 12:12:52 GMT
References: <2286@twg.bc.ca>
Organization: DataCount Register Informatici, Wierden, The Netherlands
Lines: 20

In article <2286@twg.bc.ca> bill@twg.bc.ca (Bill Irwin) writes:
>I would like to know if there is a command under SCO XENIX 2.3.3
>that will produce a checksum on a file, so that later, another
>checksum could be compared to the first;  and if different, you
>would know that the file had been modified.

There is a command 'sum' that (surprise!) calculates the checksum.
Some versions have an option -r that causes an alternative
algorithm to be used, which is better at detecting things like
swapped bytes and so (I think, not rely on this). SCO Unix has
this option, I'm not sure about Xenix.

I'm not sure this is the right newsgroup for this... comp.unix.shell?

Paul.
-- 
 ----------------
:slootman@dri.nl : When you get to the point where you think that nothing
:+ 31 5496 88831 : is impossible, try pushing toothpaste back into a tube
 ----------------