Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!uwm.edu!spool.mu.edu!agate!linus!philabs!crpmks!wizkid!admiral!deano From: deano@admiral.UUCP (Dean Carpenter) Newsgroups: comp.unix.sysv386 Subject: ISC 2.2.1 on 33MHz 486 with WD 1007V-SE2 ESDI controller Message-ID: Date: 26 May 91 16:04:34 GMT Sender: waffle@admiral.uucp (Waffle BBS User Login) Reply-To: deano@admiral.UUCP (Dean Carpenter) Organization: The Grid/Waffle BBS, 203-661-2873, -1279, -0450, -2967 Lines: 23 Has anyone had any luck installing Interactive Unix 2.2.1 on a configuration such as the above ? The doc says 2.2 couldn't but 2.2.1 was fixed to enable installation with the 1007V. When the install procedure goes to check the drive for a valid unix partition, it comes back with : Device Error: Controller command aborted. Controller 0 (Primary AT hard disk), disk drive 0, absolute sector 0 When fdisk runs, it can't find an existing DOS 3.3 partition, I assume because it can't read the drive correctly. If I make any partitions They don't get saved to the drive - that is, I can reboot with a DOS diskette and my original partitions are still there, and the new ones created with the ISC install are not. Any help ? Please reply to uunet!areyes!deano or deano@areyes.com Thanks - deano@admiral.UUCP (Dean Carpenter) The Grid/Magpie and /Waffle BBS (HST/V32) 203-661-1279 (PEP/V32) -2873 (V32) -0450 (V29/MNP6) -2967 Multiplayer Games, Multicolor Chat, Multibbses, Multifun!