Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!swrinde!zaphod.mps.ohio-state.edu!sol.ctr.columbia.edu!ucselx!maxc1503 From: maxc1503@ucselx.sdsu.edu (David Tse) Newsgroups: comp.sys.amiga.hardware Subject: Re: Help needed to pick a monitor for the A3000 Message-ID: <1991May31.100835.2533@ucselx.sdsu.edu> Date: 31 May 91 10:08:35 GMT References: <1991May23.175407.24237@ariel.unm.edu> Distribution: na Organization: San Diego State University Computing Services Lines: 25 saunders@triton.unm.edu (Richard Saunders CIRT) writes: >But my 1950 is doing pretty good. The flicker you mention at the top line >of the Workbench (which I originally had as well) can be fixed by turning >the fine-tuning screw in the back of the 3000. Tune the vertical size and position, not the screw on 3000, that's for overall adjustment, read the manual Intro. to A3000. The top line flicker has been a long thread here, there is no real cure yet, being inside the Amber chip, again, you can only hide it by monitor adjustment. >I would like to mention after being on for say, 6 hours or so, >the 1950 diplay would start to "flicker" slightly, and I was >extremely frustrated that my brand new monitor did this. >I noticed that the Monitor was pretty hot on top, and (this may sound >looney) blowing on it fixed it for a second. >So I went out and bought a little fan >to blow some air through, and my 1950 has given me no problems since. >Apparently, it needs a little more circulation. >* saunders@triton.unm.edu * "This is _NOT_ Mel Torme!" - Top Secret What does that flicker look like? it could be many reason. David