Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!zaphod.mps.ohio-state.edu!sdd.hp.com!hplabs!hpfcso!hpfcdc!rsh From: rsh@hpfcdc.HP.COM (Scott Holbrook) Newsgroups: comp.sys.hp Subject: Re: Cluster spread over two nets Message-ID: <5570657@hpfcdc.HP.COM> Date: 4 Jun 91 05:10:58 GMT References: Organization: HP Fort Collins, Co. Lines: 28 > I have an hp9000/700 as a server and 9 diskless clients. The > server has two ethernet cards one on net A and one on net B. > Now, the clients are all on net A. > I now wish to add another client, but on net B. This new > client was added using sam. It finds the server and downloads /hp-ux > but after reporting the link addresses of itself and the server, > repeatadly says `Server not responding...' and nothing else. HP-UX Diskless does not support diskless clients on multiple LANs. All clients must be on the same LAN. I'm afraid you will have to put the new client on "net A". Simply move the client to "net A" and boot it, you will not need to change any configuration files on the server. We are aware that it would be nice to support diskless nodes on multiple LANs, and that feature is currently being investigated. However, it is somewhat complicated, (from a logistical standpoint, not really a technical one) as the protocol currently does not allow for it, so a "synchronous" release of HP-UX on both the Series 700 and Series 300 would be required. Scott Holbrook HP-UX kernel lab (diskless) The opinions expressed here are mine and mine only, they do not represent an official or un-official statement of the Hewlett-Packard Company.