Path: utzoo!utgpu!news-server.csri.toronto.edu!bonnie.concordia.ca!uunet!munnari.oz.au!metro!cs.uow.edu.au!u8705377 From: u8705377@cs.uow.edu.au (Paul Anthony Wilkinson) Newsgroups: comp.sys.amiga.tech Subject: Re: A501 Clock Problem Keywords: Amiga, A501 Message-ID: <1991Jun6.131156.12025@cs.uow.edu.au> Date: 6 Jun 91 13:11:56 GMT References: <1991Jun3.174934.3543@csusac.csus.edu> Organization: Dept of Computer Science, Wollongong University, Australia Lines: 35 kelson@ais.org (David Lewis) writes: >wangf@athena.ecs.csus.edu (Out of Mind) writes: >>My clock on my A501 seems like it went dead...The computer now books up >>and says it can't find the clock? Is the battery dead? If so, how do >>you replace it and where do you get an replacement battery? I left the >>computer on for 4 hours to see if the charge is dead or what, but it >>still doesn't fix the problem. I would really appreciate it if I could >>get some help on this.... thanks :) > Well I have the same problem.. I took the expansion out.. and tested >the battery with a multimeter.. and it seemed to be putting out the >proper voltage... *sigh* >-- >Internet: Kelson@ais.org My 500 would do this sometimes before I replaced my power supply. The supply would "hiccup" and then the screen would go all sorts of strange ways. Usually after this the time was either wrong, or "clock not found". The first way to try and fix this is to use the command "setclock reset" from the CLI. If this does not work then you have to resort to more drastic measures. Remove the 501 board. If the clock chip is socketed then simply remove it and then replace it. This will reset the chip. If the chip is not socketed you can either unsolder the chip or the battery (or just let the board sit for about 3 years to let the battery run down 8-) ). Hope this is some help, Paul u8705377@wraith.cs.uow.edu.au | I can't even afford a .sig let alone opinions