Xref: utzoo comp.sys.ibm.pc:55331 comp.sys.ibm.pc.hardware:9566
Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!usc!elroy.jpl.nasa.gov!news.larc.nasa.gov!mris.larc.nasa.gov!jka
From: jka@mris.larc.nasa.gov (J. Keith Alston)
Newsgroups: comp.sys.ibm.pc,comp.sys.ibm.pc.hardware
Subject: adding second(miniscribe 3675) drive
Message-ID: <1991Jun10.142701.15733@news.larc.nasa.gov>
Date: 10 Jun 91 14:27:01 GMT
Sender: news@news.larc.nasa.gov (USENET Network News)
Distribution: na
Organization: NASA Langley Research Center, Hampton, VA  USA
Lines: 16
Originator: jka@mris.larc.nasa.gov



Hello,
     My system consists of a 386/25 with a WD1006V-SR2 RLL disk controller
     and a 65 Mbyte mitsubishi MR-535 drive. I've just purchased another
     65 Mbyte drive, miniscribe 3675. I disconnected the mitsubishi drive
     and connected up the miniscribe, and was able to format it and bring
     it up ok. What I want to do is puT The mitsubishi back as the C: (primary)
     drive and add the miniscribe as the D: drive since my controller can
     handle 2 HD's. What I need to know is are there any jumper settings
     that I should know about on either drive, or the contoller? also
     how should the setup be terminated or do I not need to worry about
     this?
				       Any help would be greatly appreciated,
				       Keith Alston
				       jka@snow.larc.nasa.goV