Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!think.com!zaphod.mps.ohio-state.edu!wuarchive!uunet!cbmvax!carolyn
From: carolyn@cbmvax.commodore.com (Carolyn Scheppner - CATS)
Newsgroups: comp.sys.amiga.programmer
Subject: Re: Overscan in C under 1.3
Message-ID: <22424@cbmvax.commodore.com>
Date: 13 Jun 91 22:45:30 GMT
References: <1991Jun11.223910.16621@athena.mit.edu>
Reply-To: carolyn@cbmvax.commodore.com (Carolyn Scheppner - CATS)
Distribution: usa
Organization: Commodore, West Chester, PA
Lines: 22

In article <1991Jun11.223910.16621@athena.mit.edu> genoa@athena.mit.edu (Jack N Holt) writes:
>
>What's the best way to open an overscan screen in C under AmigaDOS 1.3?
>I'm writing a simulation of cell growth which will need to be transfered
>to videotape, and we want it to look as good as possible...  I'm using
>SAS/C 5.10

We do not support overscan screens under 1.3.

However, if it is for transfer to videotape only, and you don't
care if you have full mouse travel to the right and bottom, then
just adjust your Preferences so the upper leftcorner of the workbench
is as far up/left as you want, and open the overscan size screen you
want.

-- 
==========================================================================
 Carolyn Scheppner -- Tech. Mgr. CATS - Commodore Amiga Technical Support
 PHONE 215-431-9180 {uunet,rutgers}!cbmvax!carolyn  carolyn@commodore.com

 I am fully operational and all of my circuits are funcTiOnINg pperrf...
==========================================================================