Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!zaphod.mps.ohio-state.edu!caen!kuhub.cc.ukans.edu!maimer From: maimer@kuhub.cc.ukans.edu Newsgroups: comp.sys.novell Subject: Re: Netware 3.11 and Zenith Message-ID: <1991Jun12.042412.31388@kuhub.cc.ukans.edu> Date: 12 Jun 91 04:24:12 CDT References: <1991Jun4.141932.27696@bronze.ucs.indiana.edu> Organization: University of Kansas Academic Computing Services Lines: 41 In article <1991Jun4.141932.27696@bronze.ucs.indiana.edu>, mckimg@bronze.ucs.indiana.edu writes: > Hello everyone, me again. > > I have set up many 3.11 servers, and have never had this problem before: > > Zenith 386 (not sure which model -- each Zenith seems to be different) > as a server. > Zenith ESDI Disk Controller (DTC) > > I am able to run 3.11 pretty much successfully except -- random characters > appear constantly on the console. The characters don't start until I load > the ISADISK driver that came with Netware. > > I have: > 1. Used two completely independent sets of disks, to check for > software corruption. > 2. Swapped in an identical DTC controller. > > Other than the character garbage, everything works beautifully -- I can log > on, transfer files, etc. > > Does anyone have any ideas for a fix? Is there a special "Zenith ESDI" > driver? > > Thanks in advance for any help you can give me!! > I have also seen the garbage on Zenith 386s. I have also been seeing it on DTK 486/25s (FEAT 2502 if you really want to get specific) using Ultrastor controllers (32K cache, I haven't tested the 1M cache yet). Since it doesn't seem to affect the operation, I've just ignored it. -- |\ \\\\__ Tony Maimer __ | \_/ o \ / | > _ (( <_ / | | / \__+___/ maimer@kuhub.cc.ukans.edu /o /_/| |/ |/ < )) _ < \ \ \| \ | +++++++++++++++++++++++++++++++++++++++++++++++++++++++++++