Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!swrinde!zaphod.mps.ohio-state.edu!rpi!crdgw1!crdos1!davidsen
From: davidsen@crdos1.crd.ge.COM (Wm E Davidsen Jr)
Newsgroups: comp.os.msdos.misc
Subject: 5note #2: booting dos from xenix
Keywords: dos5, xenix
Message-ID: <3433@crdos1.crd.ge.COM>
Date: 18 Jun 91 13:46:19 GMT
Reply-To: davidsen@crdos1.crd.ge.com (bill davidsen)
Organization: GE Corp R&D Center
Lines: 12

On a Dell 325 I have Xenix/386 and MS-DOS 5.0. If I power up and say
"dos" at the "boot:" prompt, DOS loads normally, including emm386. If I
run xenix for a while and then boot dos, the emm386 doesn't start, but
gives an error message.

Possible fix: playing with the A20 handler used...

Suggestions or actual solutions are most welcome.
-- 
bill davidsen	(davidsen@crdos1.crd.GE.COM -or- uunet!crdgw1!crdos1!davidsen)
  GE Corp R&D Center, Information Systems Operation, tech support group
  Moderator comp.binaries.ibm.pc and 386-users digest.