Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!sdd.hp.com!spool.mu.edu!olivea!tardis!tymix!uunet!mcsun!hp4nl!gufalet.let.rug.nl!rug4!laverman From: laverman@cs.rug.nl (Bert Laverman) Newsgroups: comp.sys.tandy Subject: Re: Series 1 Editor Assembler Question Message-ID: <1991Jun20.073502.14119@cs.rug.nl> Date: 20 Jun 91 07:35:02 GMT References: Sender: laverman@cs.rug.nl Organization: Dept. of Computing Science, State University of Groningen Lines: 31 Sandy Kaplan writes: >I have the original Radio Shack Series-1 Editor Assembler. It is a >cassette-based software package, however an article from 80-Micro long >ago provided a patch from Apparat that allowed disk access. My problem >is I no longer remember the command to load a source file from disk. >I've tried the obvious letter 'L', and the "Apparat Appendage Version 3.1" >banner does appear, but I immediately receive a "Bad Paramaters" error >message. I've tried L file name, plus L in combination with every >possible letter, number and symbol I can think of to no avail. > >If anyone can remember the syntax for this, I would be forever indebted. I haven't got the manuals at hand, but if I remember correct it's: L D=/ To load from tape (i.e. old style 'L' command: L T= If this doesn't work, mail me. I still got MB's of software. Personally though, I preferred using M80/L80. I even wrote an extensive graphics package with it, extending DiskBASIC to allow several new commands for drawing, including 3-D with perspective. Hope this helps Greetings, Bert -- #include Bert Laverman, Dept. of Computing Science, Groningen University laverman@cs.rug.nl bert@arrakis.nl.mugnet.org