Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!swrinde!zaphod.mps.ohio-state.edu!rpi!uupsi!cci632!tvf
From: tvf@cci632.cci.com (Tom Frauenhofer)
Newsgroups: comp.unix.sysv386
Subject: Hardware Scrolling?
Message-ID: <1991Jun19.013053.11430@cci632.cci.com>
Date: 19 Jun 91 01:30:53 GMT
Reply-To: tvf@cci.com (Tom Frauenhofer)
Organization: Computer Consoles, Inc., An STC Icon, Rochester, NY
Lines: 18

I'm having a little problem with AT&T 3.2.2 on my home system.  My set-up
is a 16 Mhz 386sx, 4 Meg ram, CGA board, AMI Bios dated 3/90, 40 Meg IDE
Hard disk.  What happens is that I occasionally get blank lines on the
display when I scroll down a lot.  I believe this is cause by something
called Hardware scrolling.  Why I believe this is that I used to run
Minix, and there was a specific section in the document that described
my problem and which function key I could hit so that I would get software
scrolling.  I don't think the card is at fault, I used to have the same
problem under Minix with a Hercules compatible monochrome card.

What can I do to correct this problem?

Thanks in advance!
-- 
Thomas V. Frauenhofer, WA2YYW, tvf@cci.com   | SPAM is a register trademark
{uupsi,ccicpg}!cci632!tvf@uunet.uu.net       |  of a pork product packed
tvf@frau.UUCP                                |  only by Geo. A. Hormel
tvf1477@ma.cs.rit.edu                        |  & Co. Corp.