Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!usc!elroy.jpl.nasa.gov!swrinde!zaphod.mps.ohio-state.edu!caen!spool.mu.edu!agate!plague.Berkeley.EDU!echuang
From: echuang@plague.Berkeley.EDU (Ernest Chuang)
Newsgroups: comp.sys.ibm.pc.misc
Subject: Re: MS-DOS 5.0: Where the @*%! is loadhigh? (followup)
Message-ID: <1991Jun20.194632.16451@agate.berkeley.edu>
Date: 20 Jun 91 19:46:32 GMT
References: <23721@shlump.lkg.dec.com>
Sender: usenet@agate.berkeley.edu (USENET Administrator)
Distribution: usa
Organization: ucb
Lines: 38

In article <23721@shlump.lkg.dec.com> reisert@mast.enet.dec.com (Jim Reisert) writes:
>
>In article <1991Jun20.090306.25375@agate.berkeley.edu>,
>	echuang@plague.Berkeley.EDU (Ernest Chuang) writes...
>>
>>Oops...I just checked the manual again and realized it was an internal
>>command, so it shouldn't be on the disks; but still, it doesn't seem
>>to recognize either "loadhigh" or "lh" ("devicehigh" works just fine).
>>Has anyone else had this problem?
>
>Are you sure you're running the COMMAND.COM that came with DOS 5.0 (and not
>4DOS, for example)?  If you are using 4DOS, you can use the command:
>
>	command /c loadhigh <your program here>
>
>to use DOS's LOADHIGH command
>
>- Jim

Thanks!  I am using 4DOS, so this was the problem.  But as a follow-up
question, what's the proper syntax for using "loadhigh" in conjunction
with "install" in the config.sys (specifically for Fastopen)?  The above 
suggested line works fine in my autoexec.bat, but when I try:

	install=command.com /c loadhigh c:\dos\fastopen.exe c:=(150,150)

I get the boot-up message "Fastopen installed.  Error in config.sys line 8"
which is the above line.  (I don't get the error when I remove that line).
It *does* load fastopen into the UMB according to mem /c, but it's kind of
irritating to get that error message every time I reboot.  I've tried a few
minor variations such as removing the extensions .com and .exe, removing
the /c switch, and just doing a straight install=loadhigh c:\dos..., but
they all give me outright errors and don't load Fastopen successfully.
(Obviously I'm just going by trial and error, but I can't seem to find the
answer in the manual :-)  Can anyone see my mistake?

	- Ernest
	  echuang@ocf.berkeley.edu