Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!ut-emx!bongo.cc.utexas.edu!condor
From: condor@bongo.cc.utexas.edu (Georgios Kontoravdis)
Newsgroups: comp.windows.ms
Subject: access COM3
Message-ID: <51347@ut-emx.uucp>
Date: 27 Jun 91 22:52:13 GMT
Sender: news@ut-emx.uucp
Reply-To: condor@bongo.cc.utexas.edu (Georgios Kontoravdis)
Organization: The University of Texas at Austin; Austin, Texas
Lines: 16
Originator: condor@bongo.cc.utexas.edu

Does anyone know how to access COM3 under Windows 3.0 in enhanced mode?
My modem is connected to COM3 and I use Procomm Plus as communication
software.  Everything works fine from DOS, but it doesn't work if
I run it from inside Windows (enhanced mode).  If I run Procomm from
Windows in real mode everything works since I can specify in the PIF
file of Procomm that this program uses COM3.

I would appreciate any suggestions or pointers where to look for the solution.

Thank you,
George Kontoravdis
(condor@ix1.cc.utexas.edu)

P.S. Please respond by sending mail to my e-address.

: