Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Posting-Version: version B 2.10 beta 3/9/83; site byucsa.UUCP
Path: utzoo!linus!decvax!harpo!utah-cs!beesvax!byucsa!jim
From: jim@byucsa.UUCP
Newsgroups: net.unix-wizards
Subject: VT131 in block mode
Message-ID: <123@byucsa.UUCP>
Date: Thu, 11-Aug-83 12:11:50 EDT
Article-I.D.: byucsa.123
Posted: Thu Aug 11 12:11:50 1983
Date-Received: Fri, 12-Aug-83 04:48:14 EDT
Organization: BYU Compter Science -- Provo UT
Lines: 13

Our link was down, not sure if this enquiry made it out,
trying again.

We have a user running an application that requires the use
of VT131's in block mode on a 11/730 under 4.1 using the
DMF32 board.  The system dies of silo overflow if baud>2400
or >1 user.  Any suggestions or similar experience would be
appreciated.  Also, are there any DMF drivers that allow the
use of the parallel port on the card?

Thanks
jim  (utah-cs!beesvax!byucsa!jim)