Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!linus!decvax!tektronix!ogcvax!omsvax!icalqa!hplabs!sri-unix!clark.wbst@PARC-MAXC.ARPA
From: clark.wbst@PARC-MAXC.ARPA
Newsgroups: net.micro
Subject: Search for Jumpers ?
Message-ID: <12184@sri-arpa.UUCP>
Date: Fri, 30-Sep-83 13:26:00 EDT
Article-I.D.: sri-arpa.12184
Posted: Fri Sep 30 13:26:00 1983
Date-Received: Thu, 6-Oct-83 20:53:41 EDT
Lines: 25

Someplace I have seen... does anybody know where I can get this, or something like it?

... A short jumper to go between wire-wrap pins.  A short (1/4"?) cylinder
slid over the pin, and the pin went right through, out the top.  A wire
went to another sleeve for the other pin.  The result was that the whole
deal did not stick up higher than the top of the wire-wrap pin.

What I need to connect is the NPG continuity jumper on a UniBus backplane.
To get from one pin to the other you go up 0.125" and left 0.125", so it is
0.177".  I can't imagine anyone making a little jumper with that fixed
distance, but...

I want to be able to remove and add it very easily, without playing with
wire-wrap wire, yet do not want something kludgy like a piece of bent
solid wire, since it will be done by non-hardware types. 

Any help would be greatly appreciated !

--Ray Clark

   Clark.wbst
   Clark.wbst@parc-maxc
   EEvax.clark.wbst@parc-maxc
   allegra!rocksvax!clark
   depending on where you are....