Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP Path: utzoo!linus!security!genrad!grkermit!masscomp!clyde!ihnp4!inuxc!pur-ee!uiucdcs!uiuccsb!dollas From: dollas@uiuccsb.UUCP Newsgroups: net.micro.cbm Subject: Re: fuse problem with C64 - (nf) Message-ID: <4477@uiucdcs.UUCP> Date: Tue, 13-Dec-83 22:28:53 EST Article-I.D.: uiucdcs.4477 Posted: Tue Dec 13 22:28:53 1983 Date-Received: Fri, 16-Dec-83 01:33:52 EST Lines: 27 #R:ihuxv:-59700:uiuccsb:16800003:000:1572 uiuccsb!dollas Dec 13 18:02:00 1983 Though your problem boils down to the fuse, it might be a different one. If you drive too many peripherals using your Commodore power supply, if you have a bad chip (the latter may be undetected unless you do something the actual chip is needed for !!!), or, finally, if you have power surges (the power company may be in fault for a few, but usually this is not the problem), you end up blowing the fuse. My opinion (which might not be of use since I don't know your exact problem) is: (1) Check the number of peripherals that you drive. If you have (or you can borrow) an ammeter find the current they draw. The maximum current ratings are specified in your reference manual. Also, (2) Remove the keyboard, and with a new fuse turn on the Commodore (be sure that before you turn it on, the keyboard is connected). Leave it like that for a few minutes, and then "feel" the different chips. Excessive heat (I have burned my fingers many a time on similar occasions) is a good indication that the chip is drawing too much current. Make sure that you touch only the top of the chip and not the contacts. Both of the above are non-hardware approaches to the subject. If you have a chronic problem, probably it would be a good idea to service it in an authorized shop. Good Luck!!!!! Apostolos Dollas Dept. of Computer Science University of Illinois (..!pur-ee!uiucdcs!uiuccsb!dollas)