Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP Posting-Version: version B 2.10.1 exptools 1/6/84; site ihuxf.UUCP Path: utzoo!linus!security!genrad!grkermit!masscomp!clyde!floyd!harpo!ihnp4!ihuxf!parnass From: parnass@ihuxf.UUCP Newsgroups: net.ham-radio Subject: Re: Shortwave Listening--Advice Wanted Message-ID: <1968@ihuxf.UUCP> Date: Thu, 26-Jan-84 08:53:20 EST Article-I.D.: ihuxf.1968 Posted: Thu Jan 26 08:53:20 1984 Date-Received: Fri, 27-Jan-84 12:26:37 EST References: <4874@umcp-cs.UUCP> Organization: AT&T Bell Labs, Naperville, IL Lines: 70 x Older Receivers for SWL'ing If you pay $400 for a 50's vintage receiver, you are paying too much! Hamfests are full of older receivers selling from $50 to $300, depending on model and condition. If you aren't adept at repairing older equipment, you must be extra careful when you buy. In this case, a private deal, along with a demonstration, may be better. SWL'ing has changed quite a bit in 25 years. Today, digital frequency readout is almost a must! This realization was driven home after using an older Hammarlund HQ-180A receiver for a few weeks. The HQ-180A was a super, top of the line radio in the 60's, but the lack of digital readout, and resolution to only about 10 KHz wasn't good enough for modern, serious SWL activity. Today's bands are much more crowded, so selectivity does indeed count. Cheaper solid state receivers are more prone to overload. If you live in an urban environment, with a high density of transmitters, this will be important. My ICOM R-70, which covers 100 KHz through 30 MHz continu- ously, has digital readout and good selectivity. R-70's may be had new for about $600. Indoor SWL Antennas MFJ, Sony, and Dymek make active indoor antennas. These consist of a 3 or 4 foot rod and a solid state amplifier. The MFJ 1020 indoor unit I use works much better than expected, although still not as good as an outdoor antenna. It lists for $80 new, but was purchased at a hamfest for $20, and needed only one minor repair (replace a fiber washer). You could go the route of running antenna wire around the inside walls of your high-rise condo. This is unsightly. A friend used the metal window frame in his Chicago apartment with an antenna tuner and 5 watt low power ham transceiver (Ten Tec Argonaut) to make dozens of foreign contacts. Mak- ing a two way DX contact is more difficult than just being able to hear a foreign station. Remember, indoor antennas are particularly prone to locally generated interference, such as harmonics of the sweep cir- cuit in a TV, home computer signals, light dimmer (SCR variety) noise, etc. Apartment dwellers are especially likely to encounter problems in this area, but don't be discouraged. Living several stories above the ground can help offset some of these handicaps. I've never tried connecting anything more than a diode and headphones to the telephone finger stop. I'm glad people are finding more uses for telephones! More Information There are other SWLs that read this news group. If you need more information, pick up a copy of Popular Communications magazine on your newsstand. Although not particularly good in technical areas, the frequency information and other articles are very interesting. -- ========================================================================== Bob Parnass, AT&T Bell Laboratories - ihnp4!ihuxf!parnass - (312)979-5760