Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP Path: utzoo!linus!decvax!harpo!ihnp4!inuxc!pur-ee!uiucdcs!uiuccsb!dollas From: dollas@uiuccsb.UUCP Newsgroups: net.micro.cbm Subject: Re: 64 cassette interface kit - (nf) Message-ID: <4850@uiucdcs.UUCP> Date: Tue, 10-Jan-84 22:29:19 EST Article-I.D.: uiucdcs.4850 Posted: Tue Jan 10 22:29:19 1984 Date-Received: Sun, 15-Jan-84 00:44:50 EST Lines: 30 #R:ariel:-53600:uiuccsb:16800005:000:1636 uiuccsb!dollas Jan 7 05:00:00 1984 With respect to the interface kit I do not know a lot. However, the interface itself is trivial (a design of my own works fine for me and I have made three more sets for friends -none of which has problems). A design -it turned out that mine is similar to it- can also be found at the September's issue of Popular Electronics. The hardware cost about $5. The success of the design largely depends on the cassette recorder, and it usually takes one hour in order to find the volume and tone levels that give the best results. In terms of time, it can be done in an evening, it takes two to four hours (most of the time is spent drilling holes in the box, stripping cables, etc, the actual connections of the electronics take around half an hour). Another aspect is the tape that you use. I found -the hard way- that a good tape is essential, so I use TDK SA-90 (this is not an advertisment, I pay for my tapes), and usually I buy a 90 minute SA-90 and load it in the shells of many bargain tapes (those 3 for $1), so the search time is smaller. If you -or any other netter- are interested in my design, drop me a line (my address follows) or send me some electronic mail and I will be glad to send you a copy. Apostolos Dollas Dept. of Computer Science Univ. of Illinois 1304 W Springfield Urbana, Illinois 61801 or, ...!pur-ee!uiucdcs!uiuccsb!dollas