Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Posting-Version: version B 2.10 UW 5/3/83; site uw-beaver
Path: utzoo!watmath!clyde!burl!ulysses!mhuxj!houxm!vax135!cornell!uw-beaver!laser-lovers
From: laser-lovers@uw-beaver (laser-lovers)
Newsgroups: fa.laser-lovers
Subject: Re: HP Laserjet
Message-ID: <2091@uw-beaver>
Date: Fri, 2-Nov-84 15:33:37 EST
Article-I.D.: uw-beave.2091
Posted: Fri Nov  2 15:33:37 1984
Date-Received: Sat, 3-Nov-84 07:14:09 EST
Sender: yenbut@uw-beave
Organization: U of Washington Computer Science
Lines: 13

From: William LeFebvre <phil@rice.ARPA>
Is it possible to put many different point sizes into the HP at the
same time?  Troff likes to have at least 12 different sizes available
at the same time (especially if you want to use eqn).  I was under the
impression that this could not be done.  If this is true, then a troff
translator isn't going to do you a whole lot of good.  You would be a
little better off with ditroff, since you can at least tell it what
point sizes are available.

                                William LeFebvre
				Department of Computer Science
				Rice University
                                <phil@Rice.arpa>