Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Posting-Version: version B 2.10.2 9/18/84; site brl-tgr.ARPA
Path: utzoo!watmath!clyde!burl!ulysses!mhuxr!mhuxt!houxm!whuxl!whuxlm!harpo!decvax!genrad!panda!talcott!harvard!seismo!brl-tgr!tgr!anonymous.FSOEP@his-phoenix-multics.arpa
From: anonymous.FSOEP@his-phoenix-multics.arpa (JGuerber)
Newsgroups: net.micro
Subject: Re: break keys
Message-ID: <9297@brl-tgr.ARPA>
Date: Mon, 18-Mar-85 09:04:14 EST
Article-I.D.: brl-tgr.9297
Posted: Mon Mar 18 09:04:14 1985
Date-Received: Wed, 20-Mar-85 04:48:06 EST
Sender: news@brl-tgr.ARPA
Lines: 16


   A while ago, someone asked about break keys; here's how I've done it:
   Hook up a SPDT switch with - common on modem's pin 3 - normally
closed on computer's pin 2 (TxD) (This would normally be connected to
the modem's pin 3) - normally open on pin 20 (DTR) of both computer and
modem.
  Depressing the switch will then pull the TxD line low for about 1/3
second, which is the standard break signal.  I have had absolutely no
problems from this set-up with my Franklin Ace 1200 and Rixon R212A
modem.I understand that it may be wise to add resistors, but since I
wasn't sure of the values I didn't; the electronics have survived thus
far.  Also, you may find it helpful to use a terminal block to make the
connections, and use alligator-clip wires at first.
   A software method I have heard of but not tried is to send a few nulls with the baud rate turned down to about 5 or so.

  -- Jeff Guerber (JGuerber.FSOEP at HIS-PHOENIX-MULTICS)