Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Posting-Version: version B 2.10.1 6/24/83; site cbneb.UUCP
Path: utzoo!linus!philabs!cmcl2!seismo!harvard!talcott!panda!genrad!decvax!bellcore!sabre!zeta!epsilon!gamma!ulysses!mhuxr!ihnp4!cbosgd!cbsck!cbneb!adm
From: adm@cbneb.UUCP
Newsgroups: net.decus
Subject: vt220 help
Message-ID: <3087@cbneb.UUCP>
Date: Tue, 9-Apr-85 09:28:52 EST
Article-I.D.: cbneb.3087
Posted: Tue Apr  9 09:28:52 1985
Date-Received: Sat, 13-Apr-85 14:55:20 EST
Sender: adm@cbneb.UUCP
Organization: AT&T Bell Laboratories, Columbus, OHIO
Lines: 18
Nf-ID: #N:cbnap:12600005:000:613
Nf-From: cbnap!gws    Apr  9 07:44:00 1985


	I have a vt220 which I run in VT100 mode most of the time.
I do however have a couple of programs that will only run on a VT52.
At the present time a run a short program to software switch from
vt100 mode to vt52 mode, This works fine, but when I want to switch
back to vt100 mode I can't. Has anyone found an escape sequence that
will permit you to switch from vt52 mode to vt100 mode or even to vt220
mode without reseting the terminal??? I have check the vt220 programmers
guide but have not found a solution.


					tnx

					Gary W. Sanders (N8EMR)
					ihnp4!cbnap!gws
					AT&T Bell Labs (Columbus,Ohio)