Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Posting-Version: version B 2.10.2 9/18/84; site unm-la.UUCP
Path: utzoo!linus!philabs!cmcl2!lanl!dspo!unm-la!jay
From: jay@unm-la.UUCP
Newsgroups: net.consumers
Subject: Re: Deadbolts in metal doors advice needed
Message-ID: <292@unm-la.UUCP>
Date: Wed, 15-May-85 13:22:15 EDT
Article-I.D.: unm-la.292
Posted: Wed May 15 13:22:15 1985
Date-Received: Thu, 16-May-85 21:59:46 EDT
References: <731@ssc-vax.UUCP> <1173@cbosgd.UUCP>
Organization: Univ. of New Mexico, Los Alamos
Lines: 17

> So all we had to do was buy 2.5" hole saws.
> . . .
> The most annoying part was having to make 3 trips to the
> hardware store for another hole saw.

No, no, no!  FIRST you go the the art supply store and buy a circle
template (make sure it has circles big enough).  THEN you go to the
hardware store.  But you don't buy a hole saw.  You buy a round file.
Go home, get a sharp #2 pencil, draw a circle where you want the hole,
drill a starter hole (as big as your largest drill bit), and start
hacking with the file.  It'll go faster than you think, not to mention
all the gas you'll save.
-- 
	Jay Plett
	{cmcl2,ihnp4}!lanl!unm-la!jay
	{ucbvax,gatech}!unmvax!unm-la!jay
	unm-la!jay@lanl.ARPA