Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP Posting-Version: $Revision: 1.6.2.16 $; site absolut.UUCP Path: utzoo!watmath!clyde!bonnie!akgua!whuxlm!spuxll!abnji!u1100a!pyuxww!gamma!epsilon!zeta!sabre!bellcore!decvax!yale!absolut!bill From: bill@absolut.UUCP Newsgroups: net.micro.pc Subject: Re: cu bug in Xenix - HELP! Message-ID: <12000013@absolut.UUCP> Date: Mon, 10-Jun-85 17:50:00 EDT Article-I.D.: absolut.12000013 Posted: Mon Jun 10 17:50:00 1985 Date-Received: Sat, 15-Jun-85 09:29:26 EDT References: <203@u1100s.UUCP> Lines: 31 Nf-ID: #R:u1100s:-20300:absolut:12000013:000:1073 Nf-From: absolut!bill Jun 10 17:50:00 1985 >***** absolut:net.micro.pc / u1100s!dqs / 3:49 pm Jun 6, 1985 >Does anybody have the following cu problem on Xenix for the AT: >Sometimes (but not always!) when I do a "~." to terminate the conversation >I get "Memory fault - core dumped", followed by my Xenix shell prompt (so I'm >out of cu) and then the system is dead - all I can do is power down! Since I >don't have the cu source code, I figure the core file is virtually useless to >me. Anybody else run into this? Any fixes?? > Dave Strauss ---------- I have come across the same problem. I can't tell you what causes the behavior but you can recover by typing -- stty saneJ -- at the prompt this should unlock your terminal. I usually "logout" at this time and log back in to get my terminal reset to its normal setttings. PS I usually get a segmentation violation not a memory fault so you may have a different problem. bill William Gibbs {ucbvax!cbosgd!ima!cfib, decvax!cca}!absolut!bill Absolut Software 617-232-8377 2001 Beacon Street Boston, MA 02146-4227