Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Posting-Version: version B 2.10.2 9/5/84; site cbnap.UUCP
Path: utzoo!watmath!clyde!cbosgd!cbdkc1!cbnap!gws
From: gws@cbnap.UUCP (Gary W. Sanders (N8EMR))
Newsgroups: net.dcom
Subject: Re: Hayes 2400 modems
Message-ID: <31@cbnap.UUCP>
Date: Thu, 1-Aug-85 08:11:34 EDT
Article-I.D.: cbnap.31
Posted: Thu Aug  1 08:11:34 1985
Date-Received: Fri, 2-Aug-85 06:04:07 EDT
References: <991@hou2h.UUCP>
Reply-To: gws@cbnap.UUCP (Gary W. Sanders (N8EMR)
Organization: AT&T Bell Labs Columbus,Ohio
Lines: 36

In article <991@hou2h.UUCP> hhs@hou2h.UUCP (H.SHARP) writes:
>I have been trying out a Hayes 2400 modem working with a 
>Teletype 5420 terminal.
>I have noticed that the Hayes modem does not raise Data Set Ready
>until it gets answer tone from the remote modem.  The Teletype
>terminal will not receive data from the modem unless Data Set Ready
>is raised.
> ......
> ......
> ......
> ......

	Try shorting pins 5 to 6 or pins 5 to 8 on the 5420,
	The 5420 will work (as you have noted) , but not 
	full function.

>Another problem I have noticed is using the Hayes to call into
>our computer.  The computer is using AT&T modems.  About three
>out of four times I call in, after I get the "Connect 1200"
>message (no 2400 bps modems on the other end) I get a line of
>garbage on the screen.  The computer times out and disconnects the
>call.  Anyone else notice this problem?

	What speed is your terminal running? I have a USR2400
	modem. If I have my terminal set to 2400baud and I connect
	to a 1200 baud modem, I get the "Connect 1200" message
	at 2400 baud but then the modem switches to 1200 baud
	and the terminal must be switched manualy to 1200 in
	order to converse with the computer..

				tnx
				Gary W. Sanders (N8EMR)
				ihnp4!cbnap!gws
				AT&T Bell Labs (Columbus,Oh)
-- 
test of sig file