Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Posting-Version: version B 2.10.1 6/24/83; site looking.UUCP
Path: utzoo!watmath!looking!jan
From: jan@looking.UUCP (Jan Gray)
Newsgroups: net.micro.mac
Subject: I did it! (more 512K Mac upgrade tips)
Message-ID: <310@looking.UUCP>
Date: Thu, 25-Jul-85 00:00:00 EDT
Article-I.D.: looking.310
Posted: Thu Jul 25 00:00:00 1985
Date-Received: Fri, 26-Jul-85 07:25:45 EDT
Organization: Looking Glass Software, Waterloo, Ont
Lines: 19

I just spent the evening upgrading my friend's Mac to 512K.  Everything
went smoothly (but slowly)...and seven hours later my (very relieved)
friend had a Fat Mac for $80 CDN.

Here are a few tips:

1.  Remember to remove the programmer's switch!

2.  It *really* pays to have a nice Weller temp. controlled soldering station,
    as the DDJ article mentions, because the magnetic tip pulls the clipped
    pins out without needing pliers.  Joy.

3.  If you can't find an Xcelite XTD-10 Torx screwdriver w/6" shaft, you
    might try a very long hex key, it worked for me.

It is a *wonderful* feeling when the Mac boots and says it has 512K!

Good luck,
Jan Gray    (watmath!looking!jan)    Looking Glass Software    519-884-7473