Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP Posting-Version: Notesfiles $Revision: 1.7.0.8 $; site waltz Path: utzoo!watmath!clyde!burl!ulysses!mhuxr!mhuxn!ihnp4!inuxc!pur-ee!uiucdcs!convex!waltz!haddock From: haddock@waltz Newsgroups: net.micro.pc Subject: Re: IBM AT Serial Line Pinouts Message-ID: <31800010@waltz> Date: Sun, 25-Aug-85 15:24:00 EDT Article-I.D.: waltz.31800010 Posted: Sun Aug 25 15:24:00 1985 Date-Received: Fri, 30-Aug-85 20:02:21 EDT References: <2077@ukma.UUCP> Lines: 62 Nf-ID: #R:ukma.UUCP:-207700:waltz:31800010:000:2113 Nf-From: waltz!haddock Aug 25 14:24:00 1985 /* Written 2:19 pm Aug 22, 1985 by ukma.UUCP!slg in waltz:net.micro.pc */ /* ---------- "IBM AT Serial Line Pinouts" ---------- */ >Does anyone out there have the pinout configuration for an IBM >serial port on the serial/parallel card? ======================================================================== If you're looking into the male, DB-9 connector from the outside, around at the back, the pins are numbered like this: |\ 1|. \ | .|6 2|. | | .|7 3|. | | .|8 4|. | | .|9 5|. / |/ The parallel port connector is oriented the same way and is directly below the DB-9. Information flow is something like this: +-------------- Carrier Detect | -------------| 1 Receive Data | ----------->>| 2 Transmit Data | <<-----------| 3 I B M Data Term. Ready | <<-----------| 4 Ground | P A R A L L E L / -------------| 5 Data Set Ready | ----------->>| 6 S E R I A L Request to Send | <<-----------| 7 Clear to Send | A D A P T E R ----------->>| 8 Ring Indicator | ----------->>| 9 | +-------------- ================================================================ _____ -Rusty- |\/ o \ o | ( -< O o Where's the fish? |/\__V__/ ARPA: Haddock%TI-CSL.csnet@CSNet-Relay.arpa or Rusty@Maryland CSNet: Haddock@TI-CSL USENET: {ut-sally, convex!smu, texsun, rice} ! waltz ! haddock