Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP Posting-Version: version B 2.10.2 9/17/84; site think.ARPA Path: utzoo!watmath!clyde!cbosgd!ihnp4!think!ejb From: ejb@think.ARPA (Erik Bailey) Newsgroups: net.micro,net.micro.pc Subject: Re: ansi.sys file Message-ID: <2863@think.ARPA> Date: Wed, 25-Sep-85 17:42:41 EDT Article-I.D.: think.2863 Posted: Wed Sep 25 17:42:41 1985 Date-Received: Fri, 27-Sep-85 04:07:52 EDT References: <1012@ariel.UUCP> Reply-To: ejb@think.UUCP (Erik Bailey) Distribution: net Organization: Thinking Machines, Cambridge, MA Lines: 35 Xref: watmath net.micro:12102 net.micro.pc:5397 In article <1012@ariel.UUCP> djm@ariel.UUCP (D.MORGAN) writes: >*** DO NOT REPLACE THIS LINE WITH YOUR MESSAGE *** >I recently purchased SuperKey by Borderland International for my >IBM XT. The instructions state that I must the install the ansi.sys >driver into my config.sys file. The problem is that I can not find >the ansi.sys file anywhere. It did not come with SuperKey and it is >no where to be found on my hard disk. I need to know how to get or >create ansi.sys. > >Tom Morgan >ariel!djm The ANSI.SYS device driver (that's what it is) should have come on you DOS disk. Check your original, if it is NOT there, than call the manufacturer of your computer. ANSI.SYS is a screen-driver program that enables IBMPCs to interpret somewhat ANSI-standard codes for screen control. You can control screen colors, cursor positioning, and even keyboard redefinition (although it is a royal pain in the as*). The file should be placed in your CONFIG.SYS (create one if you don't have it), in a line like this: DEVICE = ANSI.SYS ***NOTE*** You MUST type the (return) BEFORE hitting CTL-Z to end thye file. Failure to do this will result in a strange error @ bootup: Bad or missing ANSI.SYSSI.SYS (or something like that) Your DOS manual should have data on how to do screen control. GOOD LUCK! --Erik Brought to you by Super Global Mega Corp .com