Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Posting-Version: version B 2.10.3 alpha 4/15/85; site cae780.UUCP
Path: utzoo!linus!philabs!prls!amdimage!amdcad!cae780!rje
From: rje@cae780.UUCP (Bob Evans)
Newsgroups: net.micro,net.micro.pc
Subject: Re: ansi.sys file
Message-ID: <1382@cae780.UUCP>
Date: Tue, 24-Sep-85 18:28:13 EDT
Article-I.D.: cae780.1382
Posted: Tue Sep 24 18:28:13 1985
Date-Received: Fri, 27-Sep-85 07:19:35 EDT
References: <1012@ariel.UUCP>
Distribution: net
Organization: Tektronix, Inc. (CAE Systems Division), Sunnyvale, CA
Lines: 12
Xref: linus net.micro:10840 net.micro.pc:5104
Summary: Look in the DOS manual - Chapter 4. This will explain how to add the line DEVICE=ANSI.SYS to the CONFIG.SYS file.

In article <1012@ariel.UUCP>, djm@ariel.UUCP (D.MORGAN) writes:
> *** REPLACE THIS LINE WITH YOUR MESSAGE ***
> I recently purchased SuperKey by Borderland International for my
> IBM XT. The instructions state that I must the install the ansi.sys
> driver into my config.sys file. The problem is that I can not find
> the ansi.sys file anywhere. It did not come with SuperKey and it is
> no where to be found on my hard disk. I need to know how to get or
> create ansi.sys. 

It is assumed by Borlund that EVERYONE reads the ENTIRE DOS manual
and KNOWS it ALL ( ;-) ), Chapter 4 explains ANSI.SYS and the
CONFIG.SYS file.


Brought to you by Super Global Mega Corp .com