Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP Posting-Version: version B 2.10.3 4.3bsd-beta 6/6/85; site ucbvax.BERKELEY.EDU Path: utzoo!decvax!decwrl!ucbvax!info-vax From: Ccims.Intner@CUTC20 (Jonathan S. Intner) Newsgroups: mod.computers.vax Subject: Cable from a VAXStation to a VAX... Message-ID: <8511221018.AA16013@ucbvax.berkeley.edu> Date: Thu, 21-Nov-85 16:03:25 EST Article-I.D.: ucbvax.8511221018.AA16013 Posted: Thu Nov 21 16:03:25 1985 Date-Received: Sat, 23-Nov-85 08:11:47 EST Sender: daemon@ucbvax.BERKELEY.EDU Organization: The ARPA Internet Lines: 46 Approved: info-vax@sri-kl.arpa I am trying to run a cable through CSA0: on a VAXStation to a VAX (11/750) using one of the terminal ports on the DMF-32 on the VAX. We are going to run Kermit over the terminal line (if I can ever get the hardware figured out). No where in the manuals that came with the VAXStation do I see what the pins are going in to CSA0:...I understand that it is the console, but have heard that it can be used for this. 7 D C V 5 M p p S A 0 F i i A X | n ============================= n 0 S 3 s s : t 2 ? ? a t i o n I am not the resident cable creator, and don't know much in general about creating cables, but if I tell the person that I need pins foo on the VAX end and pins bar on the VAXStation end, then I can get a cable made. I think what is currently running between a terminal in the same room as the VAXStation and the VAX is a null modem cable, but I understand that this is not correct to go between the VAX and the VAXStation. Thanks in advance... Any replies or suggestions gratefully appreciated... Jonathan Intner Systems Programmer, CCIMS. ARPAnet: G.Intner@Columbia-20 (or CS.COLUMBIA.EDU) BITnet: INTNER@CUTCV1 CCnet: CCIMS.Intner@CUTC20 -------