Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Posting-Version: version B 2.10.3 4.3bsd-beta 6/6/85; site caip.RUTGERS.EDU
Path: utzoo!watmath!clyde!burl!ulysses!mhuxr!mhuxt!houxm!whuxl!whuxlm!akgua!gatech!seismo!caip!page%ulowell.csnet
From: page%ulowell.csnet@CSNET-RELAY.ARPA
Newsgroups: net.micro.amiga
Subject: Passing params w/LOADSEG & CREATEPROC
Message-ID: <477@caip.RUTGERS.EDU>
Date: Tue, 19-Nov-85 01:04:55 EST
Article-I.D.: caip.477
Posted: Tue Nov 19 01:04:55 1985
Date-Received: Wed, 20-Nov-85 08:28:04 EST
Sender: daemon@caip.RUTGERS.EDU
Organization: Rutgers Univ., New Brunswick, N.J.
Lines: 15

From: Bob Page <page%ulowell.csnet@CSNET-RELAY.ARPA>

How can I pass "command line" parameters to a load module that I have
loaded with LoadSeg and am about to start with CreateProc?  Note that
I can do it with Execute(" ", 0, 0) but that's not what I want to do,
since I don't want the module unloaded right after the command, I want
to restart it with new parameters w/o erasing it out of RAM.

Any assistance (direct mail to me) will be great.  I will summarize
and post to the net.

..Bob Page

UUCP: ...!decvax!wang!ulowell!page
ARPA: page%ulowell.csnet@csnet-relay