Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Posting-Version: version B 2.10.2 (Tek) 9/28/84 based on 9/17/84; site mako.UUCP
Path: utzoo!watmath!clyde!cbosgd!ihnp4!houxm!mtuxo!mtunh!vax135!cornell!uw-beaver!tektronix!orca!mako!trussell
From: trussell@mako.UUCP (Dennis Trussell)
Newsgroups: net.rec.wood
Subject: Re: rockwell speed-block sander problem
Message-ID: <960@mako.UUCP>
Date: Fri, 15-Nov-85 15:21:47 EST
Article-I.D.: mako.960
Posted: Fri Nov 15 15:21:47 1985
Date-Received: Mon, 18-Nov-85 05:28:48 EST
References: <1267@vax1.fluke.UUCP>
Reply-To: trussell@mako.UUCP (Dennis Trussell)
Distribution: net
Organization: Tektronix, Wilsonville OR
Lines: 24

In article <1267@vax1.fluke.UUCP> gsa@fluke.UUCP (Gary S. Anderson) writes:
>i have a rockwell speed-block orbital sander that exhibits a problem of running
>slow, approximately half speed, until it warms up.  it seems to run fine then.
>has anyone experienced this problem?  is there a cure?
>
>thanks,
>
>-- 
>Gary S. Anderson (206) 356-5739
>John Fluke Mfg. Co.
>P.O. Box C9090  Everett WA  98206  
>{uw-beaver,decvax!microsoft,ucbvax!lbl-csam,allegra,ssc-vax}!fluke!gsa

==========================================================================
i also have a rockwell speed-block sander with the same problem.  I took 
it apart and cleaned it, that did not help much.
	I also would like any help anyone can give me.


Dennis Trussell
ECS/mfg  GWD
tektronix, Wilsonville
Oregon
From out of the halls of the 6000 Family