Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Posting-Version: version B 2.10.3 4.3bsd-beta 6/6/85; site ucbvax.BERKELEY.EDU
Path: utzoo!decvax!decwrl!ucbvax!laser-lovers
From: laser-lovers@ucbvax.UUCP
Newsgroups: mod.computers.laser-printers
Subject: Re: Top Margin problem on Talaris Laser Printer
Message-ID: <8512180528.AA16030@g3ncal.UUCP>
Date: Wed, 18-Dec-85 00:28:51 EST
Article-I.D.: g3ncal.8512180528.AA16030
Posted: Wed Dec 18 00:28:51 1985
Date-Received: Sat, 21-Dec-85 22:09:00 EST
References: <8512111553.AA26433@marlin.ARPA>
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The ARPA Internet
Lines: 12
Approved: laser-lovers@washington.arpa

The problem is in the way a switch is set located on the cannon adapeter
board in the Talaris controller box. SWS6 (Software Switch 6) can be set to
change the paper's refererence point (Registration). Bits 1-4 control movement
in the horizontal direction and bits 5-8 control movement in the vertical
direction. There is, however, a print engine limitation which will not permit
printing in about a 1/8 inch region on the left side of the page (in portrait 
mode). By setting the registration properly, all QUIC commands will in fact
be accurate. For further information read the Quality Micro Systems LG800
operators manual which gives instructions regarding the registration adjustment.
If you have problems in performing the adjustment, Group Three Electronics
will be happy to send a trained service engineer to perform the adjustment for
you at the standard fee. Call (408) 747-1600 for information regarding service.