Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Posting-Version: version B 2.10.3 4.3bsd-beta 6/6/85; site ucbvax.BERKELEY.EDU
Path: utzoo!decvax!bellcore!petrus!sabre!zeta!epsilon!gamma!ulysses!mhuxr!mhuxt!houxm!ihnp4!ucbvax!laser-lovers
From: laser-lovers@ucbvax.UUCP
Newsgroups: mod.computers.laser-printers
Subject: Re: Wanted - Canon LPB-CX Hardware Documentation
Message-ID: <8601022230.AA13209@l5.uucp>
Date: Thu, 2-Jan-86 17:30:13 EST
Article-I.D.: l5.8601022230.AA13209
Posted: Thu Jan  2 17:30:13 1986
Date-Received: Sat, 4-Jan-86 03:24:17 EST
References: <8512151839.AA07563@topaz.rutgers
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The ARPA Internet
Lines: 17
Approved: laser-lovers@washington.arpa

(This message is posted to the whole group because the gateway
at ucbvax trashes the return address of each message, setting it
to "laser-lovers@ucbvax.uucp", so it's not possible to tell
who the sender was.)

In article <8512180533.AA16049@g3ncal.UUCP>, laser-lovers@ucbvax.UUCP writes:
> Contact Group Three Electronics at (408) 747-1800. Ask for a LG800 Service
> Manual.( The QMS LG800 uses a Cannon LPB-CX print engine)

I called Group Three today and spoke to Bonnie.  They don't have an LG800
service manual; they have a Programmer's Manual (172-0460, $35) and an
Operator's Manual (172-0461, $25).  Can the original poster clarify whether
either of these are the right manual?

	(I am John Gilmore at Nebula Consultants:

	{sun,lll-crg,ihnp4,ptsfa}!l5!gnu  or  jgilmore@lll-crg.arpa )