Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Posting-Version: version B 2.10.3 4.3bsd-beta 6/6/85; site ucbvax.BERKELEY.EDU
Path: utzoo!decvax!decwrl!ucbvax!laser-lovers
From: depaolo%marlin@NOSC.ARPA (Anthony D. dePaolo)
Newsgroups: mod.computers.laser-printers
Subject: Top Margin problem on Talaris Laser Printer
Message-ID: <8512111553.AA26433@marlin.ARPA>
Date: Wed, 11-Dec-85 10:53:03 EST
Article-I.D.: marlin.8512111553.AA26433
Posted: Wed Dec 11 10:53:03 1985
Date-Received: Fri, 13-Dec-85 01:40:30 EST
Sender: usenet@ucbvax.BERKELEY.EDU
Organization: The ARPA Internet
Lines: 16
Approved: laser-lovers@washington.arpa



When using our Talaris 800, there is a 0.4" margin that is imposed on the 
top of the page on all output, making it impossible to print on this part
of the paper.  When in QUIC command mode, regular text and line graphics
cannot use this space and if you want to print something at 1.0" down the
page, it really prints at 1.4" down.  However, when drawing arcs and when 
in vector mode, this offset does not occur, an arc or vector will print
at 1.0" down if the command line dictates this.

Anyone with a similar problem, or any solutions?  Thanks in advance.
Tony de Paolo
Naval Ocean System Center
depaolo@nosc.arpa
...!sdcsvax!noscvax!depaolo
(619)225-2772