Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Posting-Version: version B 2.10.3 4.3bsd-beta 6/6/85; site ucbvax.BERKELEY.EDU
Path: utzoo!decvax!ucbvax!laser-lovers
From: laser-lovers@ucbvax.UUCP
Newsgroups: mod.computers.laser-printers
Subject: Re: Programming LN03 question.
Message-ID: <8512132204.AA15498@sci.uucp>
Date: Fri, 13-Dec-85 17:04:17 EST
Article-I.D.: sci.8512132204.AA15498
Posted: Fri Dec 13 17:04:17 1985
Date-Received: Sun, 15-Dec-85 20:53:00 EST
References: <8512121657.AA13245@ucbvax.berkeley.edu>
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The ARPA Internet
Lines: 20
Approved: laser-lovers@washington.arpa

> I'm looking for some help in programming an LN03.  I've been trying to use the
> fonts that come with the machine in the opposite direction from what the
> default is, i.e. specifying LANDSCAPE rather than PORTRAIT.  I was under the
> impression that it would automatically rotate the font, assuming that there was
> enough memory.  However, it is not working (all I get out is black boxes for
> characters).  Is there some magic command I should be using?  (I hope it
> doesn't mean I have to buy the extra memory module!).  Thanks. 
> 							Mark London

The escape sequence I have used to print in landscape mode is:

	<ESC>[1 J

We do have an extra RAM cartridge, but I used this escape sequence
before we got the RAM cartridge and it worked.  There are some
limitations on how much data you can print without the RAM cartridge.

John Pew
Silicon Compilers
...{weitek,decwrl,oliveb}!sci!johnp