Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Posting-Version: version B 2.10.2.fluke 9/24/84; site vax3.fluke.UUCP
Path: utzoo!watmath!clyde!burl!ulysses!mhuxr!mhuxt!houxm!vax135!cornell!uw-beaver!fluke!dms
From: dms@fluke.UUCP (David Sherman)
Newsgroups: net.rec.wood
Subject: advice sought on cutting board finish.
Message-ID: <1559@vax3.fluke.UUCP>
Date: Tue, 17-Dec-85 16:01:19 EST
Article-I.D.: vax3.1559
Posted: Tue Dec 17 16:01:19 1985
Date-Received: Thu, 19-Dec-85 04:35:56 EST
Distribution: net
Organization: John Fluke Mfg. Co., Inc., Everett, WA
Lines: 14

.

	I am interested in any recommendation anyone may have for a
finish for a cutting board.  I am a little reluctant to use "danish" oil
or linseed oil since it may be toxic or at least bad tasting, but I 
would like to put something on it so it doesn't soak up water. 
Presumably there is some kind of oil which will do the job.  Thanks 
for any experience you can offer.

	David Sherman		decvax\
	John Fluke Mfg Co.	ihnp4  >!uw-beaver\
	PO Box C9090    MS 275G		   allegra >!fluke!dms
	Everett, WA 98206 USA	ucbvax >!lbl-csam /
	(206) 356-6373		hplabs/